The 1.6T EcoBoost engine found in the Fiesta ST has an 'overboost' feature from factory which allows the engine to produce more power and torque for a set period of time. When tested on the dyno in completely stock format it is not uncommon to see up to 200 bhp and 290 nm. Following an Ecusat chiptuning remap the ECU is programmed to allow the engine to run in the 'overboost mode' at all times. The tuned gains quoted on our website are what you can expect to see after a tuning session, the expected stock figures on a dyno are 200 bhp and 280 nm, please take note of this when looking at the delta gains. 

Stage 1 Remap Hardware Requirements:

• None

Stage 2 Remap Hardware Requirements:

• Full Exhaust System
• Cold Air Intake
• Front Mount Intercooler
• High Octane Fuel (Shell V Power)

Stage 3 Remap Hardware Requirements:

• Full Exhaust System
• Cold Air Intake
• Front Mount Intercooler
• Hard pipe kit with uprated turbo elbow
• Garret GTX2860R Hybrid Turbo
• High Octane Fuel (Shell V Power)